Rule Mate Fully Automatic Bilge Pump

TheAutomatic Bilge Pump provides ultimate pumping performance, which helps keep your bilge clear of nuisance water, building on the genuine Rule design. The new RuleMate bilge pumps operate using an internal level sensor. When water reaches 2" (5cm), the pump will automatically activate, removing water from the bilge. When the water level reaches 3/8" (0.9cm) the pump will turn off until the water level rises again.

Bilges are not always clean and free from debris. If the level sensor becomes fouled by debris or contaminated water, RuleMate�s unique back up feature will prevent the pump from entering a run-on condition, protecting the battery while maintaining automatic operation.

These pumps have a discharge port that is a standard �� hose barb connector (included in the package). However, the pumps are made to also accept a 1� hose barb or a 1-1/8� hose barb. Both are specific aftermarket connectors and need to be purchased separately.

With proven reliability, these pumps feature built-in switches, anti-fouling impellers and snap-off strainers for easy cleaning. 1500 and 2000gph pumps include 1" and 1 1/8" straight hose fittings and an environmentally friendly, enclosed, non-mercury float switch.

New designs include:
Higher Flow � optimized impeller to provide up to 10% more flow at the same amperage
Auto Sense Intelligence � integral water level sensor controls the pump automatically
Back Up Feature � prevents continuous running if sensor is fouled by debris, pump reverts to 2.5 minute cycle mode
Smaller Footprint � new RuleMate is 2/3 the size of existing model
Built-In Thermal Cut-Off (TCO) � provides added protection for pump and vessel
Back Flow Prevention � reduces the amount of water left over in the bilge, reducing odor and helping keep your bilge cleaner
Hidden Air Vents in the Body � helps prevent air locking in challenging plumbing installations and helps with the check valve
Threaded Discharge � easier installation, easier maintenance