Description
Trilux 33 Aerosol provides the same benefits as Trilux 33 in a convenient aerosol formula, utilizing Biolux® Slime Blocking Technology. Specially formulated in Black, Grey and White for use on aluminum outdrives and other underwater metals.
PRODUCT DESCRIPTION
Trilux 33 Aerosol antifouling paint is formulated specifically for aluminum outboards, outdrives and aluminum hulls in underwater areas. Trilux 33 Aerosol uses two biocides and Biolux technology for protection from all types of fouling. Biolux technology is used to control slime growth. Trilux 33 Aerosol is for use in fresh, salt and brackish water.
PRODUCT INFORMATION
Color YBA063A-White, YBA064A-Gray, YBA068A-Black
Finish Matte
Volume Solids 14%
Typical Shelf Life 2 yrs
VOC (As Supplied) 470 g/lt
Unit Size 16 fl.oz
APPLICATION AND USE
Preparation
BARE ALUMINUM Grind or blast the bare aluminum to a bright metal finish. For best results pre-prime using an etch primer. Remove sanding residue or any dust. Immediately apply at least 3 coats of Interprotect 2000E (first coat thinned 10 - 15%) or one full can of Primocon Aerosol Primer YPA985 in a multi-layer procedure.
PREVIOUSLY PAINTED SURFACES with Trilux 33 Aerosol or Trilux Prop & Drive Sand with 80 grade (grit) paper. with Factory Finish or Antifouling Paint Sand with 80 grade (grit) paper. Clean with Special Thinner 216. Resand any areas where bare aluminum is exposed with medium grade (grit) emery cloth and wipe clean. Follow procedure for bare aluminum above.
EPOXY Remove all surface contamination using Fiberglass Surface Prep YMA601, flush with fresh water and allow to dry. Sand with 80 grade (grit) paper. Remove sanding residue. Wipe with Fiberglass Solvent Wash 202. Apply Interprotect 2000E as primer.
Method At least 2 coats should be applied. Hold can 12-16 inches from the unit when applying the paint. Wait for minimum overcoating time between coats. Continue until the entire can has been used per outdrive. Be sure the paint is completely dry before immersion and allow minimum immersion time.
Hints
Mixing Shake can well, listen for mixing ball & continue shaking vigourously for at least 2 minutes. It is best to shake in an up and down motion. IF CAN IS NOT SHAKEN PROPERLY CLOGGING OF THE TIP MAY RESULT.
Other Put extra coats of Trilux 33 Aerosol on the props and other running gear. For best antifouling protection use entire can of Trilux 33 Aerosol for each lower unit. Further material may be required for larger units.
Some Important Points Product temperature should be minimum 10°C/50°F and maximum 29°C/85°F. Ambient temperature should be minimum 10° C/50°F and maximum 35°C/95°F. Substrate temperature should be minimum 10°C/50°F and maximum 29°C/85°F.
Compatibility/Substrates Apply to clean, dry, properly prepared surfaces only.
Number of Coats 2
Coverage (Theoretical) - 21.2 ft²/gal
Recommended DFT per coat 2 mils dry
Application Methods Aerosol can